6D93G11
1-4
1
2
3
4
5
6
7
8
9
6.
Keep a supply of clean, lint-free cloths for
wiping up spills, etc.
Good working practices
Special service tools
Use the recommended special service tools
to protect parts from damage. Use the right
tool in the right manner—do not improvise.
Tightening torques
Follow the tightening torque specifications
provided throughout the manual. When tight-
ening nuts, bolts, and screws, tighten the
large sizes first, and tighten fasteners starting
in the center and moving outward.
Non-reusable parts
Always use new gaskets, seals, O-rings, cot-
ter pins, circlips, etc., when installing or
assembling parts.
Disassembly and assembly
1.
Use compressed air to remove dust and
dirt during disassembly.
2.
Apply engine oil to the contact surfaces
of moving parts before assembly.
3.
Install bearings with the manufacture
identification mark in the direction indi-
cated in the installation procedure. In
addition, be sure to lubricate the bearings
liberally.
4.
Apply a thin coat of water-resistant
grease to the lip and periphery of an oil
seal before installation.
5.
Check that moving parts operate nor-
mally after assembly.
Safety while working
Summary of Contents for F80BETL
