Operation
66
keep the starter motor turning for
more than 5 seconds. If the starter
motor is turned continuously for
more than 5 seconds, the battery will
be quickly discharged, thus making it
impossible to start the engine. The
starter can also be damaged. If the
engine will not start after 5 seconds
of cranking, release the Start/Stop
button, wait 10 seconds, then crank
the engine again.
[ECM02491]
TIP:
If the clip is not installed to the engine shut off
switch, the buzzer will sound when the
Start/Stop button is pressed.
EMU36511
Checks after starting engine
EMU41361
Cooling water
Check for a steady flow of water from the
cooling water pilot hole. A continuous flow of
water from the cooling water pilot hole shows
that the water pump is pumping water
through the cooling water passages.
TIP:
When the engine is started, there may be a
slight delay before water flows from the cool-
ing water pilot hole.
NOTICE
ECM02251
If water is not flowing out of the cooling
water pilot hole at all times while the en-
gine is running, overheating and serious
damage could occur. Stop the engine and
check whether the cooling water inlet on
the lower case or the cooling water pilot
hole is blocked. Consult your Yamaha
dealer if the problem cannot be located
and corrected.
ZMU07147
ZMU07148
ZMU07149
ZMU05848
6AW-9-7A-1E0.book 66 ページ 2013年11月26日 火曜日 午後7時36分