Quick
START
MachXO3L SMA/DSI
Breakout Board
This document provides a brief introduction and instructions to install and run the
Lattice MachXO3L SMA/DSI Breakout Board Evaluation Kit on Windows 7/Vista/
XP. For full documentation, schematics, demonstration programs and more go
to
www.latticesemi.com/breakoutboards
and look for the MachXO3L SMA/DSI
Breakout Board.
Two versions of the Lattice MachXO3L Breakout Board are available:
MachXO3L DSI Breakout Board (LCMXO3L-DSI-EVN)
MIPI D-PHY Input and Output connectors are installed
MachXO3L SMA Breakout Board (LCMXO3L-SMA-EVN)
SMA breakout connectors are installed
This document describes either/both boards.
Check Kit Contents
The following items are included in this kit:
MachXO3L SMA/DSI Breakout Board
USB cable
QuickSTART Guide
Install USB driver & Connect the Board
1. A driver to enable the USB programming interface is included with Lattice Diamond
Programmer software. Go to
the Programmer and Deployment Tool. Be sure to include the USB driver during
installation.
2. Connect the USB cable provided between the Breakout board and your PC’s USB
port. LEDs will light and start to flash according to the preprogrammed design.
Note: Power can be supplied to the board via mini USB port, 12 V power supply,
from a separate board through the J48 DSI input connector or any combination of
the three.
Doing More
The source code for the demonstration program is available on the Lattice website (link
above). Lattice Diamond software can be used to make modifications to this program,
or develop your own designs.
For further questions contact Lattice Technical Support at:
