Operation
67
EMU27671
Warming up engine
EMU41811
Electric start models
After the engine has started, warm up the en-
gine until the engine speed settles at idling
speed. The engine warming-up indicator is
shown on the Multi-Display while the engine
warms up. For further information, see page
39.
EMU36532
Checks after engine warm up
EMU36542
Shifting
While the boat is tightly moored, and without
applying throttle, confirm that the engine
shifts smoothly into forward and reverse, and
back to neutral.
EMU41821
Stop switches
Perform the following procedure to check
that the main switch and engine shut-off
switch operate properly.
Check that the engine stops when the
main switch is turned to the “
” (off) po-
sition, or press the Start/Stop button.
Check that the engine stops when the clip
is pulled from the engine shut-off switch.
Check that the engine cannot be started
with the clip removed from the engine
shut-off switch.
EMU35881
Selecting outboard motor
(triple engine)
After all engines have started, set all control
levers to Neutral. Push the engine selector
switch repeatedly to change the digital elec-
tronic control-active indicator and select the
desired engine.
1. First, three engines can be operated.
TIP:
When all engines have started, the center
engine will run at the average speed of port
side and starboard side engines’ speeds.
Operate the port side engine using the port
1. Port side control lever
2. Starboard side control lever
3. Port side engine
4. Center engine
5. Starboard side engine
ZMU05998
P
C
S
1
2
3
5
4
ZMU05999
6AW-9-7A-1E0.book 67 ページ ２０１３年１１月２６日 火曜日 午後７時３６分
