Components
27
accident.
If the resistance does not increase even
when the lever is turned to the starboard side
“A”, make sure that the nut is tightened to the
specified torque.
TIP:
Steering movement is blocked when the
adjuster lever is set to the “A” position.
Check the tiller handle for smooth move-
ment when the lever is turned to the port
side “B”.
Do not apply lubricants such as grease to
the friction areas of the steering friction ad-
juster.
EMU32054
Power trim and tilt switch on remote
control
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pushing the switch “
” (up) trims the
outboard motor up, and then tilts it up. Push-
ing the switch “
” (down) tilts the outboard
motor down and trims it down. When the
switch is released, the outboard motor will
stop in its current position. For instructions
on using the power trim and tilt switch, see
pages 56 and 58.
EMU26156
Power trim and tilt switch on bottom
cowling
The power trim and tilt switch is located on
the side of the bottom cowling. Pushing the
switch “
” (up) trims the outboard motor up,
and then tilts it up. Pushing the switch “
”
(down) tilts the outboard motor down and
1. Nut
Nut tightening torque:
7 N·m (0.7 kgf·m, 5.2 lb·ft)
A
B
ZMU0
8
7
3
0
1
ZMU0
8
7
3
1
DN
UP
ZMU01720
6FM-28199-75-1E0.book 27 ページ ２０１９年１０月３０日 水曜日 午前１１時２３分
