Maintenance
91
Apply a light coat of oil to the gasket and
install the drain screw.
TIP:
If a torque wrench is not available when you
are installing the drain screw, finger tighten
the screw just until the gasket comes into
contact with the surface of the drain hole.
Then tighten 1/4 to 1/2 turn more. Tighten
the drain screw to the correct torque with a
torque wrench as soon as possible.
11. Add the correct amount of oil through the
filler hole.
NOTICE:
Overfilling the oil
could cause leakage or damage. If the
oil level is above the upper level
mark, drain until the level meets the
specified capacity.
[ECM01851]
12. Install the oil filler cap.
13. Leave the outboard motor for 5-10 min-
utes.
14. Remove the oil dipstick and wipe it
clean.
Drain screw tightening torque:
27 Nm (2.75 kgf-m, 19.9 ft-lb)
ZMU07020
Recommended engine oil:
F225CA YAMALUBE 4M FC-W or 4-
stroke outboard motor oil
F250CA YAMALUBE 4M FC-W or 4-
stroke outboard motor oil
F250DET1 YAMALUBE 4 or 4-stroke
outboard motor oil
F300BET1 YAMALUBE 4 or 4-stroke
outboard motor oil
F300CA YAMALUBE 4M FC-W or 4-
stroke outboard motor oil
FL250DET1 YAMALUBE 4 or 4-stroke
outboard motor oil
FL300BET1 YAMALUBE 4 or 4-stroke
outboard motor oil
LF225CA YAMALUBE 4M FC-W or 4-
stroke outboard motor oil
LF250CA YAMALUBE 4M FC-W or 4-
stroke outboard motor oil
LF300CA YAMALUBE 4M FC-W or 4-
stroke outboard motor oil
Engine oil quantity (without oil filter
replacement):
6.0 L (6.34 US qt, 5.28 Imp.qt)
Engine oil quantity (with oil filter re-
placement):
6.3 L (6.66 US qt, 5.54 Imp.qt)
1. Oil dipstick
1
ZMU07157
6CE-9-36-1E0.book 91 ページ ２０１４年１１月２８日 金曜日 午後２時５５分
©
2019 Yamaha Motor Corporation, U.S.A.
