Trouble Recovery
81
EMU29513
Power trim and tilt will not operate
If the engine cannot be tilted up or down with
the power trim and tilt because of a dis-
charged battery or a failure with the power
trim and tilt unit , the engine can be tilted
manually.
1. Loosen the manual valve screw by turn-
ing it clockwise until it stops.
2. Put the engine in the desired position,
then tighten the manual valve screw by
turning it counterclockwise.
EMU29534
Starter will not operate
If the starter mechanism does not operate
(the engine cannot be cranked with the start-
er), the engine can be started with an emer-
gency starter rope.
WARNING
EWM01023
Use this procedure only in an emergen-
cy to return to the nearest port for re-
pairs.
When the emergency starter rope is
used to start the engine, the start-in-
gear protection device does not oper-
ate. Make sure the remote control lever
is in neutral. Otherwise the boat could
unexpectedly start to move, which
could result in an accident.
Attach the engine shut-off cord to a se-
cure place on your clothing, or your
arm or leg while operating the boat.
Do not attach the cord to clothing that
could tear loose. Do not route the cord
where it could become entangled, pre-
venting it from functioning.
Avoid accidentally pulling the cord dur-
1. Fuse puller
2. Cap
3. Fuse (20 A, 30 A)
4. Spare fuse (20 A, 30 A)
1. Fuse puller
1
2
3
4
ZMU06565
1
ZMU04337
1. Manual valve screw
1
ZMU04095
6BP-9-76-1E0.book 81 ページ ２０１３年１１月１３日 水曜日 午後６時１１分
