EMX512SC/EMX312SC
50
■
INSPECTION
1.
Measurement Conditions
1-1
Environment
• Normal temperature: 5 to 40 degree
• Normal humidity: 30 to 90 %
1-2
Power Source
The voltage is within ±10 %
• U,V:
120 V
• H, W:
230 V
• B:
230 V
• A:
240 V
• K:
230 V
• O:
230 V
2.
Mixer Check
2-1
Preparation
• The load resistances for each output terminals are as follows:
10 k
Ω
(Unbalanced)
• Don’t attach load resistance to SPEAKERS terminals.
• Unless otherwise specified, the controls should be set as follows:
• CH INPUT (1-4)
LEVEL control:
Maximum (10) for measured channel only
LINE/MIC switch:
MIC
COMP control:
Minimum (0)
EFFECT control:
Maximum (10)
MONITOR control:
Maximum (10)
Equalizer gain control (HIGH, MID, LOW):
Center (0)
• CH INPUT (5/6-11/12)
LEVEL control:
Maximum (10) for measured channel only
EFFECT control:
Maximum (10)
MONITOR control:
Maximum (10)
Equalizer gain control (HIGH, MID, LOW):
Center (0)
• DIGITAL EFFECT
PROGRAM selector:
1 (REVERB HALL 1)
PARAMETER control:
MIN
DIGITAL EFFECT ON switch:
OFF
• MAIN (STEREO)
Graphic equalizer fader (7-band):
Center (0)
EFFECT RETURN control:
Maximum (10)
MASTER control:
Maximum (10)
• MONITOR
Graphic equalizer fader (7-band):
Center (0)
EFFECT RETURN control:
Maximum (10)
MASTER control:
Maximum (10)
• PHANTOM switch:
OFF
• POWER AMP switch:
MAIN L/R
• YS Processing switch:
OFF
• STAND-BY switch:
OFF
• Unless otherwise specified, the input signal should be 1 kHz sine wave.
• The input signal impedance should be 150
Ω
.
Nominal
(with
▼
mark)
Maximum
Minimum
Summary of Contents for EMX312SC
