DVD-C996/DV-C6280
DVD-C996 DV-C6280
13
■
DISASSEMBLY PROCEDURES
(Remove parts in the order as numbered.)
Fig. 2
1. Removal of Top Cover
a. Remove 4 screws (
q
) and also 3 screws (
w
) in
Fig. 1.
2. Removal of Tray Ass'y
a. Remove 1 screw (
e
) in Fig. 1.
b. Turn Gear/L0 as shown in Fig. 2 counter clockwise
gradually till immediately before the tray starts to
move and stop it there.
CAUTION:
Gear/L0, if turned counter clockwise con-
tinuously, will mesh with the gear of the tray
and the tray will come out. When removing
the tray, use care so that Gear/L0 will not
mesh with the gear of the tray.
c. Pull out the Tray Ass'y.
IMPORTANT: Installation of Table.
Install the table according to the following procedure.
1) Slide the Lever so that the Gear/RT becomes
free. (Fig.B)
2) With the “
▲
” mark on the Gear/RT aligned
with the same mark on the Tray, lock it with
the Lever. (Fig.B)
3) Install the Table by aligning it to the thick line
on “
/
” mark. (Fig.3)
*Check that the Table is locked after installation.
Fig. 1
Lever
Tray
Gear/RT1
Fit the Gear/RT to “
▲
” mark.
Fig. B
Fit the table to the thick line on “
/
” mark.
q
q
w
Tray
Tray
Gear/L0
r
e
Top Cover
Plate/Table
Lock
Unlock
3. Removal of Table
a. Remove 2 screws (
r
) and then remove the Roller
Ass'y in Fig. 3.
b. Remove the Plate/Table in Fig. 3.
c. Remove 1 screw (
t
) and then take off the Table in
Fig. 3.
Fig. A
●
Precaution for installation of the Tray Ass'y.
On Tray Ass'y setting.
Check the Direction of marking “
▲
” on gear
according to this drawing.
Gear/L0
Front Panel
Gear/L01
Marking
Fig. 3
t
