Appendix
94
Error Messages
MIDI buffer memory has become full by receiving too much
MIDI data at a time via MIDI IN or TO HOST. Reduce the
amount of data (data transfer rate) or increase the interval
between each transfer on the sending device.
An error has occurred while MIDI data was being received.
Check if the MIDI cable is properly connected and if the
MIDI data is appropriate.
All setting data is initialized because the backup battery inside
the DTXTREME IIs may be running short. Consult your
nearest Yamaha dealer on replacing the battery.
The backup battery inside the DTXTREME IIs may be
running low. All setting data may be lost if the DTXTREME
IIs is turned off after this message is shown. First try to save
necessary data to a memory card or so on, then consult your
nearest Yamaha dealer on replacing the battery.
Checksum of the received bulk data is incorrect. Check if the
data is not corrupted and appropriate for the DTXTREME
IIs, and then retry.
Received bulk data contains illegal data. Check if the data is
not corrupted and appropriate for the DTXTREME IIs, and
then retry.
This message will be shown if you attempt an operation while
the internal sequencer is running. Stop the sequencer and
retry.
This message will be shown if you attempt recording to
operation to the track that contains data. Retry recording to
an empty track.
User memory has become full. Save necessary user data to the
memory card and clear unnecessary data to release the
memory.
This message will be shown if you attempt saving onto a
write-protected memory card. Cancel write-protection of the
memory card and retry.
ERROR : MIDI input buffer full
push [ENTER]
ERROR : MIDI data error
push [ENTER]
WARNING: All data initialized
push [ENTER]
WARNING : Battery voltage is low
push [ENTER]
ERROR : MIDI check sum error
push [ENTER]
ERROR : MIDI Illegal data
push [ENTER]
ERROR : Sequencer is Running
push [ENTER]
ERROR : Sequence data is not empty
push [ENTER]
ERROR : Memory full
push [ENTER]
ERROR : Card is write protected
push [ENTER]
