II-42
6-3 MP1Z, GT15, GT20
Enter sensor test mode: 1A + 3B + 4C +
[POWER]
●
Key sensor
1-beam continuous
Slowly depress key and confirm by listening to the buzzer. (Use headphones.)
Check:
• Confirm that all points K1 to K4 are reached.
• Confirm that the key depth for K1 is 2.7 mm.
Adjustment is usually not required except when replacing the sensor unit. When replacing the sensor
unit, adjust the sensor height so that when black keys are depressed the gap between the top of the sen-
sor and the bottom of black keys is 3.5–4 mm, and then carry out sensor calibration as described below.
Key Sensor Calibration
This key sensor has a calibration function.
You can use the following procedure to access Maintenance mode, set K1-K4 for each key, and write to flash
memory.
Normally this procedure is not necessary, but should be executed in the following cases.
1. If for some reason the key sensor was exchanged.
2. If the relative position of the keyboard and sensor changed significantly due to performing the Key
Height Adjustment or Key Depth Adjustment.
3. If there is unevenness in the volume of each key, and there were significant discrepancies when K1-K4
were checked in sensor test mode.
Preparations: Remove the top board, upper front board, and key stop rail.
[All key measure]
K1
K2
K3
K4
Item
Operation
Response
Start-up
10F#+12G#+14A#+Power ON
Chord Once/2sec.
Ready
Wait for 30-40sec. (stabilize the output of light-emit-
ting components)
Start
Press the damper pedal once
Chord Once/sec.
Open position measurement Pull the key shutter up and out of the sensor unit.
(Raise the key.) Each key should rise once.
It is not necessary to raise all 88 keys simultaneously.
Write to RAM
Press the damper pedal once
Chords Double continuous stroke
Reset position measurement Lightly stroke near the key button of all keys, so that
the keys are not floating.
Write to RAM
Press the damper pedal once
Chords Triple continuous stroke
End position measurement
Play key 1-88 (chromatic scale)
Write to RAM
Press the damper pedal once
Chord Once/2sec.
Store to flash memory
Press the soft pedal once
76C Triple or four continuous
stroke
................
Summary of Contents for disklavier MX-100A
