Yamaha disklavier Mark III Series, User Manual

Page: 77 / 83

65
English Chapter 14: Using the PianoSmar
t Featur
e
PianoSmart Recording
During recording, songs can be recorded as MIDI
data while a CD is being played back. You can
record your song onto Memory Disks or a floppy
disk.
When Recording a New Song
1a
Specify a disk.
Use the disk in SMF format.
Note:
If you are recording to a floppy disk,
make sure that the disk’s erasure
protection tab is set to “unprotected”.
☛
Unformatted disks must be formatted before
use with the Disklavier. See “Formatting
Disks” on page 17 in the Advanced
Operation Manual.
If an E-SEQ type disk is used, the
following display appears when you
attempt to start recording, and
recording is disabled. Use the disk in
the SMF format.
1b
Use the [SELECT] buttons to select
the number of the memory disk
that will serve as the recording
destination.
A new song number is created for the new
recording. For example, if the last song to
be recorded was No.6, then the new song
will be No.7.
2
Specify the CD that is to be
recorded.
When you insert CD into the CD drive, the
letter “Cd” automatically appear on the left
side of the display.
3
Press [SONG SELECT] to select the
song on the CD that is to be
recorded.
4
Press [REC] to engage the Record
Standby mode.
The REC indicator lights and the
PLAY/PAUSE indicator flashes.
The currently selected CD song is recorded.
5
Press [PLAY/PAUSE] and recording
will begin.
The PLAY/PAUSE indicator stops flashing.
Start playing your song with the CD sound.
The following display appears.
“PS” indicates PianoSmart.
6
When you finish playing, press
[STOP].
When Re-recording
Re-recording the Same Song on the
Same CD
1
Specify the CD that is to be
recorded.
When you insert CD into the CD drive, the
letter “Cd” automatically appear on the left
side of the display.
2a
Specify a disk.
Note:
If you are recording to a floppy disk,
make sure that the disk’s erasure
protection tab is set to “unprotected”.