3
Turn on your piano, and reset settings on your control unit
to its factory default.
For details on setting, refer to your piano’s owner’s manual.
Turn off your piano, and disconnect the power cable from
the AC wall outlet.
Note:
The location of the TO CONTROL
CABLE FOR PIANO connector
varies depending on the piano model.
Disconnect the control cable from the TO CONTROL
CABLE FOR PIANO connector on the rear panel of your
control unit.
Loosen the two screws attached to the connector using a
screwdriver.
Attention:
DKC-850 does not work properly if
the control cable is connected
directly to it. Use the supplied
conversion cable to connect your
piano and DKC-850.
Connect the supplied conversion cable to the control cable
disconnected in step 2.
Tighten the two screws attached to the connector using a
screwdriver.
Connect the supplied conversion cable to the TO PIANO
connector on the rear panel of DKC-850.
Tighten the two screws attached to the connector using a
screwdriver.
See “Connecting Monitor Speakers”
on page 4.
Connect monitor speakers to the OUTPUT jacks on the rear
panel of DKC-850.
Connect the supplied AC adaptor to the DC-IN 12V
connector on the rear panel of DKC-850.
Connect the supplied power cable to the AC adaptor.
Connect the power cable extended from your piano and the
AC adaptor to the AC wall outlet.
See “Setting the Type of Your Piano”
on page 5.
The connection completed.
Turn on DKC-850, and set the piano type.
Important
•
Be sure to backup the data on your existing control unit to a floppy disk before connecting.
•
Please keep your original control unit for future maintenance.
1
2
3
4
5
6
7
8
9
