PERIODIC MAINTENANCE AND ADJUSTMENT
6-11
6
TIP
When only changing the engine oil, re-
move drain bolt A. When changing the
engine oil and cleaning the engine oil
strainer, remove drain bolt B also.
4. Clean the engine oil strainer with
solvent, and then check it for dam-
age and replace it if necessary.
5. Check the O-ring for damage and
replace it if necessary.
6. Install the engine oil strainer, com-
pression spring, O-ring and engine
oil drain bolt, and then tighten the
drain bolt to the specified torque.
TIP
Make sure that the O-ring is properly
seated.
7. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the oil filler
cap.
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE
ECA11620
●
In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of “CD” or oils of a high-
er quality than specified. In
addition, do not use oils labeled
“ENERGY CONSERVING II” or
higher.
●
Make sure that no foreign mate-
rial enters the crankcase.
1. Engine oil drain bolt B
2. O-ring
3. Compression spring
4. Oil strainer
ZAUU0707
1
1
3
2
4
1. Engine oil drain bolt A
Tightening torque:
Engine oil drain bolt A:
20 Nm (2.0 m·kgf, 14 ft·lbf)
Engine oil drain bolt B:
20 Nm (2.0 m·kgf, 14 ft·lbf)
ZAUU0706
1
Recommended engine oil:
See page 8-1.
Oil quantity:
0.90 L (0.95 US qt, 0.79 Imp.qt)
U2EPE0E0.book Page 11 Thursday, January 2, 2014 11:19 AM
