8
Inserting & Removing CDs
1
Press the CD eject button so that
the CD tray pops out about 1 cm.
Then, carefully pull it out as far as
it will go.
Note:
The CD eject button can be used only
when the DCD1+PS is turned on.
2
<To insert a CD> Place the CD on
the tray and gently press down
on it so that the center of the CD
is clamped in place.
Note:
Always place the CD with the label
side facing up.
<To remove the CD> Slowly lift
the CD.
3
Gently push the tray back in until
it clicks into place.
STANDB
Y
ON
PLAY/P
AUSE
DISKLA
VIER CD
PLAYER
DCD1
STOP
SONG S
ELECT
REPEAT
BALANC
E
MIN
MAX
•
•
VOLUM
E
–10
0
•
•
•
•
•
•
•
•
•
•
•
STANDB
Y
ON
PLAY/P
AUSE
DISKLA
VIER CD
PLAYE
R DCD1
STOP
SONG S
ELECT
REPEAT
BALANC
E
MIN
MAX
•
•
VOLUM
E
–10
0
•
•
•
•
•
•
•
•
•
•
•
Using the Remote
Control
The DCD1+PS is equipped with a remote control
which allows convenient control from almost
anywhere in the room. This chapter provides
notes on handling the remote control.
Installing Batteries in the
Remote Control
Before the remote control can be used, the two
batteries supplied with the DCD1+PS must be
installed.
1
Remove the battery cover from
the back of the remote control by
sliding the cover in the direction
of the arrow.
2
Insert the first battery with the
+ side first.
3
Insert the second battery by
pressing the – side to the spring
in the battery compartment while
pushing in the + side.
Note:
Make sure that the + and – are properly
oriented to the markings on the inside
of the battery compartment.
4
Close the battery cover.
