RIVAGE PM10 System Setup Guide
24
)
Fader
This is a touch-sensitive 100mm motorized fader. In
SENDS ON FADER mode, this fader adjusts the send
level of the signal sent from each channel to the
currently-selected MIX/MATRIX bus.
!
SAFE R indicator
Lights if the channel is set to Recall Safe.
@
SAFE M indicator
Lights if the channel is set to Mute Safe.
#
ISOLATE indicator
Lights if the channel is “Isolated.”
$
[CUE] key
Selects the channel for cue.
1
PIN indicator
Lights when the Pinning function for the [TOUCH
AND TURN] knob is ON.
(This feature will be supported by a future update.)
2
[TOUCH AND TURN] knob
Controls the parameter of the knob you are touching
on the touch screen.
3
Channel strip encoder display
Indicates the function that has been assigned to the
channel strip encoder.
4
UP [
U
]/DOWN [
D
] keys
Enable you to select the function that you want to
control using the channel strip encoder.
5
[SHIFT] key
Combine with another key to perform a certain
function.
The following table shows examples of using the
[SHIFT] key combined with another key. For more
information, please refer to the Operation Manual.
6
[SENDS ON FADER] key
Turns SENDS ON FADER mode on and off.
7
INPUT [1-72]/[73-144] keys
Enable you to select an input layer.
8
OUTPUT [MIX]/[MATRIX] keys
Enable you to select an output layer.
9
[DCA] key
Enables you to select a DCA layer.
)
CUSTOM [1]/[2] keys
Enable you to select a custom layer. You can assign
custom faders of two banks (total of 12 layers) to each
custom layer.
!
Layer display
Indicates the selected layer.
1
3
5
6
7
8
9
)
!
#
2
@
4
Procedure
Function
Press and hold down the
[SHIFT] key and [CUE]
key.
To switch cues as the
channel’s send destination.
(A
➝
B
➝
A&B
➝
A)
Summary of Contents for CS-R10
Page 1: ...CONTROL SURFACE CS R10 CS R10 S System Setup Guide EN ...
Page 54: ......
