75
Appendix
Assembling the Clavinova
5.
Connect the pedal cord.
5-1
Insert the plug of the pedal cord into the pedal
connector.
5-2
Attach the cord holders to the rear panel as
shown, then clip the cord into the holders.
5-3
Use a vinyl tie to take up any slack in the pedal
cord.
6.
Connect the power cord.
6-1
For models that feature a voltage selector: Set
the voltage selector to an appropriate voltage.
6-2
Insert the plug of the power cord into the power
connector.
7.
Set the adjuster.
Rotate the adjuster until the pedal box comes in
firm contact with the floor surface.
8.
Attach the headphone hanger.
Use the included two screws (4 x 10 mm) to
attach the hanger as shown in the illustration.
Voltage Selector
Before connecting the AC power cord, check the setting of the
voltage selector which is provided in some areas. To set the
selector for 110V, 127V, 220V or 240V main voltages, use a
“minus” screwdriver to rotate the selector dial so that the
correct voltage for your region appears next to the pointer on
the panel. The voltage selector is set at 240V when the unit is
initially shipped. After the proper voltage has been selected,
connect the AC power cord to the AC IN and an AC wall
outlet. A plug adaptor may be also provided in some areas to
match the pin configuration of the AC wall outlets in your area.
WARNING
An improper voltage setting can cause serious damage to
the instrument or result in improper operation.
5-1
5-2
5-3
6-1
6-2
240
127
110
220
PEDAL
Insert the pedal cord securely until
the metal part of the cord plug
disappears from view. Otherwise,
the pedal may not function properly.
