Yamaha BEARTRACKER YFM250XC, Service Manual

Page: 85 / 398

3 - 31
INSP
ADJ
FINAL DRIVE GEAR OIL REPLACEMENT/DRIVE SHAFT DUST
BOOT INSPECTION/STEERING SYSTEM INSPECTION
7.Install:
●
Filler bolt (final drive gear case)
NOTE:
After filling the oil, inspect the oil leaks.
Recommended oil:
SAE 80 API “GL-4” hypoid gear
oil
If desired, and SAE 80W90
hypoid gear oil may be used
for all condition.
Periodic oil change:
0.25 L (0.21 Imp qt, 0.27 US qt)
Total amount:
0.27 L (0.24 Imp qt, 0.29 US qt)
T
R
.
.
Filler bolt (final drive gear case):
23 Nm (2.3 m • kg, 17 ft • lb)
DRIVE SHAFT DUST BOOT INSPECTION
1.Inspect:
●
Dust boot 1
Wear/Damage
→
Replace.
Loose clamp 2
→
Tighten.
Refer to the “REAR SHOCK ABSORBER
AND SWINGARM” section in CHAPTER 7.
STEERING SYSTEM INSPECTION
1.Place the machine on a level place.
2.Check:
●
Steering shaft bushings and bearings
Move the handlebar up and down, and/or
back and forth.
Excessive play
→
Replace the steering
shaft bushings and or bearings.
Refer to “STEERING SYSTEM” section in
the CHAPTER 7.
3.Check:
●
Tie-rod ends
Turn the handlebar to the left and/or right
until it stops completely, then slightly
move the handlebar from left to right.
Tie-rod end
1
has any vertical play
→
Replace the tie-rod end(s).
Refer to the “STEERING SYSTEM” section
in CHAPTER 7.
3