Yamaha BBT 500H, Owner'S Manual

Page: 8 / 21

8
STATUS
DATA/CTRL BANK MSB/MAX
BANK LSB/MIN
TOGGLE ON-OFF
/NUMBER OF PGM
DEC
/NO INC
/YES
MEMORY
EDIT
PC
EDIT WRITE
/EXIT ± 10
8.8.8
.
Before making any connections, make sure that the power on
the BBT500H and all other related devices is switched OFF.
!4
Speaker(s)
Save patches to a
MIDI device
Use a MIDI controller to select
patch memory
MIDI IN
MIDI OUT
Outboard Effects Processor
Mixer or Additional Amplifier
OUT IN
Panel Controls and Connections
!5 !6 !7 !8 !9 @0 @1 @2
Headphones
Tuner
AC Power
Supplied power
cable
@4
@3
@5
Rear Panel
!4
Tuner Output (TUNER OUT)
This output jack is used to connect a tuner to the BBT500H.
It can also be used to create a bi-amp system. Connect this output jack
to the INPUT jack on another BBT500H. (
→
pg. 14)
!5
Effect Loop (FX LOOP)
• Effect Send Jack (SEND)
• Effect Return Jack (RETURN)
• Effect Loop Level Switch (LEVEL)
These jacks let you insert an outboard effects processor between the
SEND and RETURN jacks to apply effects to the BBT500H’s signal.
Use the Level Switch to match the Input/Output level with the level re-
quired by the outboard effects processor. Use the BLEND control in the
Compressor Mode to adjust the balance level between the outboard
effector’s sound and the sound that is created by the BBT500H. (
→
pg.
13)
!6
Headphones Jack (PHONES)
This jack is used to connect a pair of headphones to the unit. It carries
the same signal that is delivered from the LINE OUT jack. Use the LEVEL
control to adjust the volume.
!7
Headphones/Line Out Level Control (LEVEL)
Adjusts the output level of the PHONES jack and the LINE OUT jacks.
(The same setting is applied to both jacks.)
!8
Line Out Jack (UNBALANCED OUT, BALANCED OUT)
These jacks carry the signal that is selected with the
!9
Line Out Source
Switch at a line level.
Both unbalanced phone type (+4 dB/10 k
Ω
) and balanced XLR type
(+4 dB/600
Ω
) jacks are provided.
Use the LINE SOURCE switch to select the signal that is sent to the
LINE OUT jack. As the unit is equipped with an output limiter and speaker
simulator (can be switched ON/OFF), and the output level of these jacks
is controlled by the LEVEL control, these jacks can be used to send a
line level signal to a mixing console or an additional amplifier.
!9
Line Out Source Switch
(LINE SOURCE: THRU/PRE EQ/POST EQ)
This switch is used to select the signal that is delivered from the LINE
OUT jack.
THRU ........... Delivers the signal received via the INPUT jack without
alteration.
Select this setting when connecting to a DI (Direct In-
jection) box.
PRE EQ ....... Delivers the signal before it has been processed by the
tone controls (the Sound Type is active).
This setting can be used when separate EQ settings
are required for speaker and line outputs.
POST EQ ..... Delivers the signal after it has been processed by the
tone controls.
Clamp Filter (
→
pg. 17)
* For U.S. and Canadian
models only