12
The BBT500H also features more precise settings for defining the fre-
quencies for each of the Tone Control knobs, operating the Compressor
and Noise Gate, or setting the Blend Level of the effect loop, etc.
To access these settings, press the [FUNCTION] switch and use the
four Modes described below.
• Amp Mode
In this mode, each knob functions in the manner it is labeled on the
front panel.
• Equalizer Mode
This mode is used to set the 1-band parametric equalizer and the
center frequency for each of the Tone Controls (Bass – Treble).
• Compressor Mode
This mode is used to set the Compressor’s blend level, noise gate
level, and effect loop.
• Utility Mode
This mode is used to set the crossover filter, and individual MIDI
settings.
Individual settings in the Amp Mode, Equalizer Mode, and Compressor
Mode are saved when patch data is saved to the unit’s memory.
Individual parameter settings in the Equalizer Mode and Compressor
Mode are set to their default values when the power is switched ON.
Individual settings in the Utility Mode are saved when exiting the Utility
Mode, and they are retained even if the power is switched OFF.
Detailed Parameter Settings
Amp Mode
Each knob functions in the manner it is labeled on the panel.
In the Amp Mode, the knob’s value (or patch’s setting value) is shown
on the display when the knob is turned.
* After the BBT500H’s power is switched ON or the [MANUAL] switch is
pressed, nothing is shown in the display until a Memory is recalled, or a
mode other than the Amp Mode is selected.
Enter the Amp Mode using one of the following methods.
• The Amp Mode is the default mode when the BBT500’s power is
switched ON.
• Press the [MANUAL] Switch to enter the Amp Mode.
• Press a Memory Switch [1] – [5] to recall a patch. Or, press and
hold a Memory Switch to save a patch to memory.
• In the Equalizer, Compressor, or Utility Mode, press the [FUNC-
TION] switch.
●
How Knobs Function in the Amp Mode
The knob’s value is shown on the display
when the knob is turned.
q
Each control knob’s function in the Amp Mode is the same as de-
scribed in the “Sound Setting” section (
→
pg. 10).
q
INPUT LEVEL: Sets the Input Level
w
SOUND TYPE: Selects the Sound Type (11 types)
e
COMP: Compression Ratio (1.0 to
∞
, 16 steps)
r
GAIN: Pre-Amp Gain (0 to 10, 0.1 step)
t
MASTER: Master Volume (0 to 10, 0.1 step)
y
BASS: Bass Frequency (-15dB to +15dB, 0.2dB step)
u
LOW MID: Low Mid Frequency (-15dB to +15dB, 0.2dB step)
i
MIDDLE: Middle Frequency (-15dB to +15dB, 0.2dB step)
o
HIGH MID: High mid Frequency (-15dB to +15dB, 0.2dB step)
!0
TREBLE: Treble Frequency (-15dB to +15dB, 0.2dB step)
!1
OUTPUT: Sets the output level
w
e
r t
y u
i o
!0 !1
Summary of Contents for BBT 500H
Page 21: ...WC95000 Printed in China ...
