En
23
Connection diagram
Refer to the following diagram and connect the speakers to the unit.
Y
When using only one surround back speaker, connect it to the SINGLE jack (L side).
Connecting speaker cables
Speaker cables have two wires. One is for connecting the negative (-) terminals of the unit and
the speaker to each other, and the other is for the positive (+) terminals. If the wires are colored
to prevent confusion, connect the black wire to the negative and the other wire to the positive
terminal.
1
Remove approximately 10 mm (3/8”) of insulation from the ends of the speaker cable and twist
the bare wires of the cable firmly together.
2
Loosen the speaker terminal.
3
Insert the bare wires of the cable into the gap on the side (upper right or bottom left) of the
terminal.
4
Tighten the terminal.
Using a banana plug
(U.S.A., Canada, China and General models only)
1
Tighten the speaker terminal.
2
Insert a banana plug into the end of the terminal.
Connecting the subwoofer
Use an audio pin cable to connect the subwoofer.
1
2
SURROUND
CENTER
FRONT
SINGLE
SURROUND BACK
/ ZONE2 / BI-AMP
/ ZONE2
SPEAKERS
SUBWOOFER
SURROUND
F.PRESENCE
EXTRA SP1
EXTRA SP2
1
6
7
2
3
4
5
9
9
E
R
The unit (rear)
FR
ONT
1
1
2
2
4
4
3
3
+ (red)
- (black)
FR
ONT
1
1
2
2
Banana plug
Audio pin cable
