Edit
MONTAGE Reference Manual
87
Reference
Delay (LFO Delay Time)
Determines the delay time between the moment you press a key on the keyboard and the moment the LFO
comes into effect.
Settings:
0 – 127
Fade In (LFO Fade In Time)
Determines the amount of time for the LFO effect to fade in (after the “Delay” time has elapsed).
Settings:
0 – 127
Hold (LFO Hold Time)
Determines the length of time during which the LFO is held at its maximum level.
Settings:
0 – 126, Hold
Hold:
No fade-out
Fade Out (LFO Fade Out Time)
Determines the time over which the LFO effect is faded out (after the “Hold” time has elapsed).
Settings:
0 – 127
Key On Reset (LFO Key On Reset)
Determines whether or not the LFO is reset each time a note is pressed.
Settings:
Off, Each-On, 1st-On
Each-On:
The LFO resets with each note you play and starts a waveform at the phase specified by the Phase
parameter.
1st-On:
The LFO resets with each note you play and starts a waveform at the phase specified by the Phase
parameter. If you play a second note while the first is being held, the LFO continues cycling according to the same
phase as triggered by the first note—in other words, the LFO only resets if the first note is released before the second
is played.
Loop (LFO Loop)
Determines whether the LFO Wave plays through a single time (off) or continuously (on).
Settings:
Off, On
Phase (LFO Phase)
Determines the starting phase point for the LFO Wave when it is reset.
Settings:
0°, 90°, 120°, 180°, 240°, 270°
Element Phase Offset (LFO Element Phase Offset)
Determines the offset values of the “Phase” parameter (above) for the respective Elements.
Settings:
0°, 90°, 120°, 180°, 240°, 270°
Destination (LFO Destination)
Determines the functions which will be controlled by the LFO Wave.
Settings:
Insertion Effect A Parameter 1 – 24, Insertion Effect B Parameter 1 – 24, Level, Pitch, Cutoff, Resonance, Pan, E.LFO
Speed
Depth (LFO Depth)
Set the LFO Wave Depth (amplitude) for “Destination” parameter (above).
Settings:
0 – 127
Element Depth Ratio (LFO Element Depth Ratio)
Determines the offset values of the “Depth” parameter (above) for the respective Elements.
When set to “Off,” the LFO effect is not available. This is available only when Element-related parameters
are set in “Destination.”
Settings:
Off, 0 – 127
