Yamaha 2004 Rhino 660 YXR660FAS, Owner'S Manual, Page: 62 / 154

6-3
NOTE:
_
If the engine fails to start, release the key, and
then try starting again. Wait a few seconds
before the next attempt. Each cranking should
be as short as possible to preserve battery
energy. Do not crank the engine more than
5 seconds on each attempt.
_
5. If the engine is started with the starter
(choke) in position
1
, the starter (choke)
should be returned to position
2
to warm
up the engine. If the engine is started with
the starter (choke) in position
2
, keep
the starter (choke) in this position to
warm up the engine.
6. Continue warming up the engine until it
idles smoothly and return the starter
(choke) to position
3
before riding.
CAUTION:
_
See the “Engine break-in” section prior to
operating the engine for the first time.
_
EBU01800
Starting a warm engine
To start a warm engine, refer to the “Starting a
cold engine” section. The starter (choke)
should not be used. Press the accelerator
pedal slightly.
EBU90028
Jump-starting
Jump-starting the vehicle should be avoided.
The battery should be removed and charged
instead. (See pages 8-41–8-42 for battery re-
moval and installation procedures.) However,
if the vehicle must be jump-started, proceed
as follows.
1. Turn the key to “OFF”.
2. Open the hood. (See page 8-6 for hood
opening and closing procedures.)
3. Remove the battery case cover.
U5UG10.book Page 3 Friday, August 1, 2003 7:40 PM