Setting the Input Channels from the Display
19
01V96i—Reference Manual
Input
Channels
• MIX
This parameter sets the mix balance of dry (Input Chan-
nel) and wet (delayed) signals.
• FB.GAIN
This parameter sets the amount of delay feedback.
Gating Input Channels
To set the Input Channel gates, use the [SEL] buttons to select
the desired Input Channel, then press the DISPLAY ACCESS
[DYNAMICS] button, then press the [F1] button. The
Dynamics | Gate Edit page appears.
1
KEYIN SOURCE
Select one of the following buttons to determine the trig-
ger source for the currently-selected Input Channel’s gate.
•
SELF
......................... The selected channel’s own input sig-
nal is the trigger source.
•
CHANNEL
............. Another Channel’s input signal is the
trigger source. Select the desired
channel in the parameter box below
the CHANNEL button.
•
AUX
......................... An Aux Send signal is the trigger
source. Select the desired bus in the
parameter box below the AUX but-
ton.
2
STEREO LINK
This parameter’s ON/OFF button enables you to pair
gates for stereo operation even when the Input Channels
are not paired.
3
CURVE
This area displays the current gate curve.
4
TYPE
This area displays the current gate type (GATE or DUCK-
ING).
5
Meters
These meters indicate the levels of the post-gate signals
and the amount of gain reduction.
6
ON/OFF
The ON/OFF button turns the currently-selected Input
Channel’s gate on or off.
7
PARAMETER
These controls enable you to set the gate parameters. (See
page 148 for more information on the parameters.)
Tip:
•
This function is unavailable for the ST IN Channels.
•
The delay time range depends on the sampling rate at which
the 01V96i is operating.
•
If you select the DELAY SCALE meter or feet button, the dis-
tance value can be converted to the delay time based on sonic
speeds (about 343.59 m/sec at 20 degrees Celsius). This option
is useful if you wish to correct the timing difference between
two sound sources that are far apart.
•
If you select the DELAY SCALE beat button, a parameter box
for setting a note that represents the beat and a parameter box
for a tempo (BPM) setting appear below the DELAY SCALE
parameter. Setting the note and BPM settings in these param-
eter boxes enables you to set a delay time that synchronizes to
the song tempo.
3
4 5
2
1
7
6
Note:
You cannot change the gate type on this page. To
change the gate type, recall a program that uses the desired
gate type from the Gate library.
Tip:
•
This function is unavailable for the ST IN Channels.
•
You can store the gate settings in the Gate library, which
features preset programs that can be used for various
applications (see page 79).
