28
Key Fob Battery Change
When the battery is low the LED will glow dimly
when any key is pressed. The battery is changed as
follows:
1.
Slide the lock slide to unlock the cover. Remove
the rubber cover and unscrew to open the case.
2.
Insert new CR2032 coin cell battery with the +
side uppermost.
3.
Replace battery cover.
Press any key and check that the LED lights. If the
LED lights the new battery installation is successful.
Key Pad Battery Change
When the battery is low the LED will flash when any
key is pressed. The battery is changed as follows:
1.
Put Control Panel into programming mode to
prevent a tamper alarm.
2.
Unscrew the two Key Pad case screws and
remove Key Pad back to reveal battery.
3.
Using a screwdriver gently lever out the old
battery.
4.
Insert new CR2032 coin cell battrey with the +
side uppermost.
5.
Press battery into holder firmly with finger and
thumb until a click is heard. (see picture below.)
6.
Press a number key and check that the LED
lights. If the LED lights the new battery installation
is successful, screw the Key Pad case back on
and the battery change is complete.
IMPORTANT
Insert the battery under the two
tabs and click into place.
Insert flat head screwdriver to
remove battery
Battery Removal and Insertion Key Pad
28
