21
feature to be switched on and off.
• Warning on is the factory default.
Time
The Control Panel uses a 24 hour clock. The time
is set by using the
pq
keys and confirmed by
pressing the
3
key.
Date
The day and month are set by using the
pq
keys
and confirmed by pressing the
3
key.
Supervision
Enable or disable supervision detection on the
Control Panel. PIR Motion Detector, Door/Window
Contact, Smoke Detector and External Siren can
be monitored for outage using this feature. With
the exception of the Smoke Detector (which is
always on), the other three accessories need to
have supervision enabled on board to facilitate this
feature.
• Default setting is Disable (recommended).
Final Door
If this is turned On, a system counting down under
the full arm mode will immediately arm when user
exit and triggers the Door/Window Contact’s close
position (Applies to door contact with “entry”
attribute only).
• Final Door Off is the factory default.
Tel. Settings
This menu allows you to program up to 3 telephone
numbers, record an address message and place
test calls. The following items can be selected.
• Tel. Numbers
• Rec. Address
• Test Report
Tel. Numbers
This menu has a list of 3 telephone numbers. These
numbers are dialed in order, a maximum of 20 digits
per number can be stored. Only one number is
required to enable the Control Panel to report over
the telephone line.
1.
Use the
pq
keys to select a number from the
list.
2.
Press
3
to confirm. If there was a number already
stored then you will be asked to change the
number, if the slot was empty you will be asked to
enter a new number, confirm by pressing
3
.
3.
Enter your phone number and confirm by
pressing
3
. Press “Up arrow” key for
*
key (insert
3 seconds time gap, useful for switchboard) and
“Down arrow” key for the # key.
• Errors can be corrected by pressing
P
to
backspace, pressing
P
repeatedly will take
you back the telephone number list. Telephone
numbers can be deleted in the same manner.
Rec. Address
This menu allows the recording of your address.
The maximum length of message is 10 seconds
which is ample for most messages, when recording
remember to speak clearly and slowly into the
microphone.
1.
Press
3
and you will be either asked to record a
new message or change an old one.
2.
Press
3
again and follow the on screen
instructions. When you finish recording remember
to press
3
to stop recording. If you go over the
10 second recording time (indicated by a beep)
just repeat the recording procedure again taking
care not to go over the 10 second time limit. The
recording is complete.
Test report
This menu allows you to test the telephone reporting
feature.
• Please check with the call recipients before making
a test call.
• Ensure that the phone cord is connected.
1.
Select Test report and press
3
.
2.
A list of numbers will be displayed, select the
number you want to test and press
3
.
3.
The Control Panel will now display call progress.
• The address message and pre-recorded
emergency, burglar and acknowledgement
request messages will be played in a loop for 85
seconds.
• The test can be cancelled at any time by either
pressing the
P
button or the call recipient
pressing “9” on their phone to acknowledge the
call. If a radio DECT or mobile phone is used,
remember to press 9 repeatedly until the call
closes.
• Check that the call has been successfully
received.
21
