20
premises before the system arms. Times can be set
from 00 seconds (no delay) up to 70 seconds in 10
second increments.
• 30 seconds is the factory default.
Select using the selection keys, if you want to set
entry time for Away or Part Arm mode and press V
3
Entry Sound
The Control Panel will beep during the entry delay
period as an entry warning, you can switch the
sound on and off with this setting.
• Entry sound on is the factory default.
Exit Sound
The Control Panel will beep during the exit delay
period as an exit warning, you can switch the sound
on and off with this setting.
• Exit sound on is the factory default.
Door Chime
Any Door/Window Contact or PIR Motion Detector
set to entry will cause the Control Panel to chime
when activated when the system is disarmed. This
is used to signal when someone has entered your
premises. You can switch the sound on and off with
this setting.
• Chime off is the factory default.
DC Open/Close
If this is turned On, the Control Panel will sound a
door chime and display a fault message when user
tries to arm the system with Door/Window Contact
opened.
• DC Open/Close Off is the factory default.
LCD Backlight
The Control Panel display LCD can be turned on
Permanently or set to auto turn off after 30 seconds
of last key pressed.
• Auto off is the factory default.
Key Tone
The Control Panel can be made to beep when a key
is pressed. Key Tone can be selected to On or Off.
• Key Tone On is the factory default.
Ring Tone
The Control Panel can be made to beep when the
phone is ringing, you can switch the sound on and
off with this setting.
• Ringing off is the factory default.
Alarm Length
The Siren (both external and built-in) will sound when
an alarm is activated. The length of the alarm can be
set from 1 to 10 minutes in 1 minute increments with
this setting.
• 3 minutes is the factory default.
Panel Siren
You can disable the Control Panel’s built-in siren with
this setting.
• Siren on is the factory default.
Jamming Det
Enable or disable Jamming/Interference detection on
the Control Panel. Confirmed by pressing the
3
key.
Default setting is Disable (recommended).
KF Entry
When selected as Off, user must first trigger an entry
sensor before the Key Fob can disable the system.
Please select On if you which to disarm the system
without first triggering an entry sensor.
• KF Entry Off is the factory default.
• If the Key Fob’s panic button is triggered, the
same Key Fob cannot be used to silence the
External Siren.
Tamper Alarm
If set to Away Arm only, it will trigger the alarm when
tamper is active under Away Arm mode (also known
as Full Arm). It will only give a fault LED indication in
all other mode. If set to Normal, a tamper condition
will always triggers a burglar alarm under Disarm,
Home Arm and Away Arm mode.
• Away Arm Only is the factory default.
Mobility CHK (for elderly or infirm)
If there is no movement around the house for a
preset period of time (from home omit sensors under
Part Arm and all sensors under disarm mode), an
emergency alarm will be activated and reported over
the telephone line. Any key pressed on the Control
Panel and entry sensor triggering will reset the
countdown timer. The monitoring can be disabled
or set at 4, 8 and 12 hour.
• Disable is the factory default.
Siren Delay
This setting allows a delay before the Control Panel
and External Sirens are activated. You might want to
use this if you do not want the Control Panel to draw
attention to itself during an alarm, to give it time to
dial out on the telephone line. The delay can be set
from Disable (no delay) to 10 minutes in increments
of 1 minute.
• Disable is the factory default.
20
