Proc_Cal_014: Load Weight Zero Point
WHEN TO PERFORM
Performed by the operator when the no-load weight
displayed on the screen with the forks in the "weigh-
ing position" is not within ±2 percent of truck capacity.
(This is ±45.4 kg (100 lb) for a 2268 kg (5,000 lb)
truck).
This procedure will write a value to the Tare Weight
memory location. If you are going to perform
Proc_Cal_015 Loaded Weight Calibration, you can
skip this procedure as its value will be overwritten.
CALIBRATION ORDER
1.
Proc_Cal_001
2.
Proc_Cal_014
WHY PERFORM
Allows the system to take into account the weight of
the carriage assembly for weight displays.
HOW TO PERFORM
WARNING
Keep yourself and all others clear of the lift mech-
anism. Never allow anyone under or on the forks.
Never put hands, arms, head, or legs through the
mast or near the carriage or lift chains. This warn-
ing applies not only to the operator but also the
helper. A helper must not be near the load or the
lift mechanism while the operator is attempting to
handle a load. The lift mechanism has moving
parts with close clearances that can cause seri-
ous injury.
Refer to Table 16 for the procedures on how to per-
form Proc_Cal_014: Load Weight Zero Point.
Table 16. Proc_Cal_014: Load Weight Zero Point
A. TYPICAL DISPLAY WITHOUT KEY, WITH OPTIONS
B. TYPICAL DISPLAY WITH KEY, WITHOUT OPTIONS
Proc_Cal_001: Service Password Entry before proceeding.
Action 1:
Start Engine.
Action 2:
Position Mast Vertical.
Action 3:
With No Load, Activate Lift Control to Raise Forks/
Attachment Approximately 0.6 m (2 ft), But If Freelift Is Present,
Not More Than Maximum Freelift.
You Will See:
Main Menu
Passwords
Proc_Cal_014: Load Weight Zero Point
8000 YRM 1134
40
Confidential/Proprietary - Do Not Copy or Duplicate
