Yale ERC40VH, Manual

Page: 95 / 105

without reporting an impact event. Read and record the value, from the dash display, that was triggered a Soft
Impact when abruptly stopping the truck. Change the Soft Impact Force threshold to the next highest setting.
To adjust the hard threshold, take the soft threshold value and add 0.3 g. Set the Hard Impact Time to 2.
Monitor truck during all normal operations. If impacts are recorded during normal operations, go to
(
Readjustment of Soft and Hard Impact Settings ).
Readjustment of Soft and Hard Impact Settings.
If the majority of impacts recorded during the initial adjustment period are soft impacts, change the settings as
follows:
• Increase the Soft Impact Time by 1 for large scale adjustments.
• Increase the Soft Impact Force by 0.1g for smaller adjustments.
• Increase the Hard Impact Force to the current Soft 0.3g.
If the majority of impacts recorded during the initial adjustment period are hard impacts, change the settings
as follows:
• Increase the Hard Impact Time by 1 sample for large adjustments.
• Increase the Hard Impact Force by 0.1g for smaller adjustments.
After making the necessary adjustments, have the operator again operate the lift truck under normal
conditions to ensure that the adjustments are correct.
AUTO POWER-OFF TIME DELAY
NOTE:
This submenu is available to logged in Supervisors and Service Technicians.
This menu can be used to adjust the setting for the amount of time before the truck enters the Power Off
mode.
Figure 55 shows an Auto Power-Off Delay Setup Screen that has a 20m delay setting value, which is a
20 minute delay.
Figure 55. Auto Power-Off Time Delay Setup Screen
To change the Auto Power-Off Time Delay setting, select the current value. When a box is around it, press the
Enter Key , then use the number keys to enter a value from 0 to 30 minutes and press the Enter Key to save
the new setting.
RETURN TO SET TILT
NOTE:
This submenu is available to logged in Supervisors and Service Technicians. It is visible only