NOTE:
A Service Technician-level password is required to input an initial Supervisor password for
the lift truck. Once an initial Supervisor password is installed, that Supervisor-level password access
can be used to add, delete, or edit additional Supervisor passwords as well as Operator passwords.
Perform the following steps to set up a password:
1.
Using keys 0-9, enter a valid password.
2.
Press the
Enter Key
to input the password to the system. Once you press the
Enter Key
, the system
uses the five most recently entered valid numbers to compare with the currently stored password list.
3.
If the password entered does not match any currently stored password, an invalid password screen is
displayed for up to five seconds or until the user starts to enter another password, as shown in
Figure 17. Invalid Password Screen
4.
Once the system accepts the entered password, the operator is granted access to the menus associated
with that password (i.e., menus displayed at Operator-level, Supervisor-level, or Service Technician-
level access).
NOTE:
In certain circumstances a default operator password of 11111 will be in the currently stored
password list.
NOTE:
If there are no Service Technician-level passwords in the currently stored password list, the
factory default Service Technician-level password, 55555, can be used to gain access to the
system.
Use the factory default Service Technician-level password, 55555, when installing the lift truck at the
customer location to set up customer passwords. When initial installation is complete, choose a new Service
Technician-level password. However, once a new Service Technician-level password has been assigned,
55555 is no longer a usable password and it cannot be assigned as a password through the screen menu or by
using the PC Service Tool. (If all Service Technician-level passwords are deleted, the system again accepts the
55555 default password.) If there is only one Service Technician password and it is lost, the password can be
reset using the PC Service Tool.
ADDING/REMOVING/CHANGING PASSWORDS
The Add/Remove Password submenu is accessible through the Truck Setup Menu and it is visible at Service
Technician and Supervisor password access levels. This menu allows a Service Technician or a Supervisor to
Summary of Contents for ERC40VH
