Yaesu ZCUT-870, Instruction Manual, Page: 8 / 12

S etting the T ape Length and C u t- P iece S pacing
You can adjust the length and cut-piece spacing
whether Z CUT-87 0 is "ON" or "OFF".
■
Turn the LENGTH ADJUSTMENT KNOB to the desired tape length.
(The number which is pointed in approx imate Millimeter.)
(The actual length differs from the shown length depends on the type
of tape and its condition.)
■
Turn CUT-PIECE SPACING KNOB to the desired spacing.
(Make sure to keep the proper space between the cuts to avoid
tape overlapping.)
8
S etting the M ode
Cut-Piece Spacing Knob
Length Adjustment Knob
As depend on the terms of use, please select from different kinds of mode.
In the case of following changes,Sensor Mode A Sensor Mode B Preset Mode Setting
the Blade Close Mode, please press the START BUTTON longer until buzze r sounds.
The START BUTTON should be pressed longer when you prefer setting the blade close mode.
When you prefer setting the blade open mode, you just press the START BUTTON shorter.
(Even for setting the blade open mode, buzze r will sound.)
Setting the blade close mode will be available for all setting the mode of Sensor Mode A,
Sensor Mode B, and Preset Mode.
If power switch turns on while pressing the START BUTTON, you will be able to set the number
of cut as you desire.
Please refer to the illustration as below.
Setting the Blade Close Mode
■
Press the START BUTTON longer and setting the blade close mode will be done.
■
Setting the blade close mode means both upper blade and lower blade are closed when the cutting
blade stops. Press the START BUTTON longer if you prefer this mode. This mode will be suitable
for cutting the ext endible tapes.
■
Setting the blade open mode means both upper blade and lower blade are opened when the cutting
blade stops. Press the START BUTTON shorter if you prefer this mode.
■
When power switch turns on, the cutting blade will remain opened.
SENSOR MODE A
(Blue light is on)
SENSOR MODE B
(Purple light is on)
PRESET MODE
(Red light is on)
POWER SWITCH ON
START BUTTON
Setting the number
of cut
Press shorter (Blade stops and opens)
Press longer (Blade stops and closes)
Setting the Blade Close Mode
(Purple light is flashing)