11
①
⑤
②
③
④
Before replacing the blades, make sure
the POWER SWITCH is "OFF".
WARNING: The blades are very sharp.
Whenever replace the blades, do not
touch the blades and use pliers.
The blades are consumable, and they will eventually
worn out.
If it happens, please replace a new one.
The staying power of blades are based on the tape's
quality, material, thickness which you are using.
Replacing the Upper and Lower Blades
Lower Blade Stopper
Upper Blade
Lower Blade
Lower Blade
Screw
Lower Blade Press
Lower Blade Press
Slider
Fulcrum
Projection
Press the Lower Blade Press
Insert the Slider's pin to
the oval shape hole
How to Remove the UPPER BLADE
How to Remove the LOWER BLADE
How to Replace the LOWER BLADE
■
Turn the POWER SWITCH off and unplug the cord.
■
Slide SAFETY COVER to the direction of OPEN to open SAFETY
COVER.
■
Take the screw out of the UPPER BLADE.
■
Replace the new blade.
■
Make sure that SAFETY COVER is definitely closed after setting
tape.
■
Plug in the cord and turn the POWER SWITCH on and test to cut.
■
Turn the POWER SWITCH off and unplug the cord.
■
Slide SAFETY COVER to the direction of OPEN to open SAFETY
COVER.
■
For easy remove, turn the LENGTH ADJUSTMENT KNOB to the
limit.
■
Press the LOWER BLADE PRESS and raise the LOWER BLADE
STOPPER. [
①
-
②
]
■
Hold the projection of right side of the LOWER BLADE by pliers. [
③
]
■
Turn 180 degrees to the left and take the LOWER BLADE out from
the fulcrum. [
④
]
■
Put the LOWER BLADE back to fulcrum.
■
Turn the LOWER BLADE until the SLIDER's pin can insert the oval
shape hole of the LOWER BLADE. [
⑤
]
■
Pull the LOWER BLADE STOPPER down.
(If the blades are not set properly, the machine is at risk of damege.)
■
Make sure that SAFETY COVER is definitely closed after setting
tape.
■
Plug in the cord and turn the POWER SWITCH on then test to cut.