10
10
Maintenance
■
If you have been using ZCUT-870 for a long time, tape residue starts to stick on the blades, and it
becomes harder to cut. Remove tape residue with alcohol.
■
Check the screw of UPPER BLADE regularly.
If the screw is loosen, ZCUT-870 can not cut the tape properly.
■
If the tape can not stick on the TURN TABLE, clean the TURN TABLE by using alcohol with a clean dry
cloth, or swab remove the residue.
When performing any maintenance,
make sure ZCUT-870 is "OFF".
■
When you carry ZCUT-870, please hold the bottom of machine.
Do not grab the TURN TABLE.
■
Make sure the POWER SWITCH is "OFF" when you set the tape.
■
Please follow the instructions when you set the tape.
(If you can not make it, read Instruction Manual carefully and do it over from the beginning.)
■
When ZCUT-870 is not in use, please unplug and switch OFF the POWER SWITCH.
■
When you finish using ZCUT-870, remove all the tape from the TURN TABLE.
■
Please do not modify ZCUT-870 by yourself.
■
ZCUT-870 is designed for tape cutting only. Please do not cut any other things.
■
ZCUT-870 is designed for industrial use.
(It is not recommended to use at home. Do not use around children.)
■
During the operation, if ZCUT-870 stops suddenly or make strange noise, please stop using ZCUT-870
immediately and send it back to us for checking or repairing.
■
If ZCUT-870 is broken, please send it to us with the existing tape that you have been used.
■
If you have any questions about your using tape, please contact us and send a sample roll for evaluation.
Our Recommendation
Warning: The BLADES are very sharp.
Do not touch the BLADES by hand.
■
Press the ROLLER LOCK LEVER inward.
■
Turn the BRAKE ROLLER until can not turn.
(With the roller locked the tension may cause the length to vary.)
(Cut several sample pieces and adjust the length if you needed.)
(Press the RELEASE BUTTON when you need to release the lock.)
Dealing with Curling Tape
Roller Lock Lever
Release Button
Brake Roller