7
Start Button
Tape Holder Adjustment Lever
Tape Support Bar
Brake Roller
Slit
Turn Table
Loading the Tape
Make sure to turn the POWER
SWITCH off, and according to
Instruction Manual when you set
the tape.
WARNING: Whenever you set
the tape, do not touch the
UPPER and LOWER BLADES.
■
Make sure the SUPPORT STAND in use.
■
Make sure the POWER SWITCH is off and plug in.
■
Turn the POWER SWITCH ON.
( A lightly beep sound will come out then the START BUTTON lights
and shows the mode color. )
( The default on this tape dispenser sets number of cut. Red color
light on which means 2 pcs. is set. )
■
Slide SAFETY COVER to the direction of OPEN to open SAFETY
COVER.
( The START BUTTON is flashing with Red light. )
■
Press the START BUTTON and move the CUTTER BLADE ARM
little by little.
( Catch the timing where the cutter blades open most widely. )
( Press the START BUTTON continuously, the CUTTER BLADE
ARM moves intermittently. )
■
Turn the POWER SWITCH OFF.
■
Plug the cord out.
■
Pull the TAPE SUPPORT BAR out to the limit.
■
Pull the tape under the BRAKE ROLLER.
■
Put the tape between the TAPE HOLDER, hooked by TAPE
SUPPORT BAR and through the SLIT (between UPPER and
LOWER BLADE) and affix the tape to the TURN TABLE.
■
Adjust the TAPE HOLDER to the proper width by sliding the TAPE
HOLDER ADJUSTMENT LEVER.
■
Slide SAFETY COVER to the direction of CLOSE to close SAFETY
COVER.
■
Plug in the cord.
■
Turn the POWER SWITCH ON.
■
Press the START BUTTON.
( When you use AUTO MODE A (Blue light on) or AUTO MODE B
(Purple light on), stop rotating the TURN TABLE at the SENSOR
which you set. When you use PRESET MODE (Red light on), the
TURN TABLE stop rotating after finishing numbers of cut. )