VX-7R O
PERATING
M
ANUAL
32
T
ONE
S
EARCH
S
CANNING
In operating situations where you don’t know the CTCSS or DCS tone being used by
another station or stations, you can command the radio to listen to the incoming signal and
scan in search of the tone being used. Two things must be remembered in this regard:
¦
You must be sure that your repeater uses the same tone type (CTCSS vs. DCS).
¦
Some repeaters do not pass the CTCSS tone; you may have to listen to the station(s)
transmitting on the repeater uplink (input) frequency in order to allow Tone Search
Scanning to work.
To scan for the tone in use:
1.
Set the radio up for either CTCSS or DCS Decoder operation (see the previous discus-
sion). In the case of CTCSS, “
TSQ
” will appear on the display; in the case of DCS,
“
DCS
” will appear on the display.
2.
Press the
key, then press the
key to enter the Set mode.
3.
Rotate the
DIAL
to select the Menu Item labeled (
TSQ
/
DCS
/
DTMF #2: TONE SET
) when TONE SQL is selected,
or Menu Item labeled (
TSQ
/
DCS
/
DTMF #3: DCS SET
)
during DCS operation.
4.
Press the
key to enable adjustment of the selected
Menu Item.
5.
Press the
key, then press the
key to start scanning
for the incoming CTCSS or DCS tone/code.
6.
When the radio detects the correct tone or code, it will halt on that tone/code, and
audio will be allowed to pass. Press the
key to lock in that tone/code, then press
PTT
to exit to normal operation.
If the Tone Scan feature does not detect a tone or code, it will continue to
scan indefinitely. When this happens, it may be that the other station is not
sending any tone. You can press the
PTT
switch to halt the scan at any time.
You also can press the
MONI
key during Tone Scanning to listen to the (muted) signal
from the other station. When you release the
MONI
key, Tone Scanning will resume after
about a second.
Tone Scanning works either in the VFO or Memory modes.
A
DVANCED
O
PERATION
