VR-500 O
PERATING
M
ANUAL
23
Mode Scan
The VR-500 may be programmed to scan only those Memory Channels on which a par-
ticular emission mode has been programmed (such as NFM, AM, etc.).
To set up Mode Scanning:
•
Switch to the VFO mode by pressing the
[CLR (P.SET)]
key.
‚
Press the
[ENT(SET)]
key while pressing the
[FUNC]
key to activate the "Set" (Menu)
mode.
ƒ
Rotate the
DIAL
knob to select Menu #16 [Mode Scan].
„
Rotate the
DIAL
knob while pressing the
[FUNC]
key to se-
lect the Receive Mode which you wish to scan during Memory
Scanning (all channels set to other modes will be ignored).
…
Press the
[CLR (P.SET)]
key to exit to normal operation.
†
Press the
[1(MEMO)]
key while pressing the
[FUNC]
key to
enter the Memory mode.
‡
Press the
[3(SCH/SCN)]
key while pressing the
[FUNC]
key to initiate Mode Scan-
ning. Only the channels which were stored with the same Receive Mode will be scanned.
ˆ
To return to normal Memory Channel Scanning, re-enter the "Set" (Menu) mode, and
set Menu #16 to OFF.
D
ELETING
M
EMORY
C
HANNELS
You may wish to delete a certain Memory Channel's data, when you no longer have a
reason to recall that channel.
To delete a channel's data:
•
Recall the Memory Channel to be deleted.
‚
Press the
[2(MW/MC)]
key while pressing the
[FUNC]
key.
You will observe “
Clear?
” on the display.
ƒ
Press the
[2(MW/MC)]
key again while pressing the
[FUNC]
key to delete the Memory Channel.
Important Note: Deleted Memory Channel data can not be restored.
Memory Mode
Receive Mode
