28
Installation and Connection
Installing the Radio
Installing the controller
Install the controller using the provided bracket.
Caution
The bracket can be bent by hand to match the location where the controller is going to be installed.
Take due care not to injure yourself when bending the bracket.
1
Select the installation location
Caution
Select a stable, flat location with as few dents and protrusions as possible.
Tip
Also refer to “Installation location when used in a mobile unit” ( P.24).
2
Fix the bracket to the controller using the
provided screws and washers, as shown in the
drawing
コントローラ
ブラケット
ネジ
ワッシャー
Controller
Bracket
Washer
Screw
3
Peel off the protective seal from one side of the
provided two-sided adhesive sheet, and paste it
onto the bottom of the bracket
保護
シール
両面接着
シート
Protection
seal
Two-sided
adhesive
sheet
4
Peel off the other protection seal from the
underside of the two-sided adhesive sheet pasted
onto the bracket, and then stick the bracket to the
installation location
Caution
Remove all dirt and dust from the installation
location before affixing the bracket.
保護シール
Protection seal
Summary of Contents for FTM-400XDR/DE
Page 218: ...218 Appendix Note...
