11
12
Befor
e Use
Befor
e Use
There are 5 levels for CLEAN and NEO DYHP Modes, and 3 levels for EYE Mode.
Each time the CLEAN or NEO DYHP button is pressed, the level switches as shown in the below picture.
* There is no level selection available for COOL Mode.
* Use only Level 1 upon the first use and until you are accustomed to use.
Level Indicator
One short beep will sound to indicate the half-way point in the operation time.
Refer to pages 9-10 for operation times in each mode.
Level 1
Level 2
Level 3
Level 4
Level 5
Timer
• This mode cares for the skin around the eyes using two electrodes on the electrode head.
• Rotate the electrode head 180° to switch between EYE Mode and Standby Mode.
The electrode head only rotates in the direction of the arrow shown in the figure
on the right.
• The device cannot be operated in Eye Mode if the electrode head is not rotated 180°.
In addition, the device cannot be used in other modes while the electrode head
is rotated.
How to Use EYE Mode
When treatment on a certain mode is completed, two short beeps sound and the device switches to Standby
Mode (the state in which functioning is suspended). Refer to pages 9-10 for operation times in each mode.
Briefly press the Mode button again to start the selected mode.
Standby Mode
EYE Mode Electrodes
* *Rotates only as far
as 180°.
CLEAN/NEO DYHP Mode
EYE Mode
2
Apply skin-care product (gel or lotion) or water on your arm.
Use the device for approx. 5 minutes in NEO DYHP Mode.
• Do not wet or rub the pre-testing area.
Pre-testing on Skin
* When using the device or a cosmetic product for the first time, always test for compatibility.
1
Clean your skin.
• Wash the inside of your wrist with soap, then wiping it dry with a towel.
If you experience any skin abnormality (redness or burning sensation) at the pre-testing
area within 24 hours, stop using the device.
ATTENTION
• Be sure to perform a pre-test in order to prevent skin problems from occurring.
• If a rash, reddening, itchiness, stinging sensation or other abnormalities occur at the
pre-testing area, immediately stop the pre-test and wash the area.
• Check carefully to make sure there is no skin abnormality before using the device. Stop
using the device immediately if the treatment does not agree with your skin.
