5
Install the sensor chip.
Note the orientation of the
sensor chip on the spool
ring.
Feed both parts of the
spool ring through the
center hole of the spool
and assemble them
together.
04
05
Use a Phillips head
screwdriver to loosen the
securing screws of the
filament spool ring.
Lower the filament spool
holder on the back side of
the printer until horizontal.
Separate the spool ring
from both sides of the
spool.
Place the assembled
filament spool (with the
spool ring) on the spool
holder.
Take out the filament spool
and the sensor chip.
Use a Phillips head
screwdriver to tighten and
secure the spool ring to
complete the installation.
01
01
02
02
03
06
*If you have just unboxed the da Vinci nano, the sensor chip should
already be loaded.
Printer Setup
Replace the New Filament Spool
Installing the Filament
Note
•
The filament will load better
when the tip of the filament
is cut at a 45° angle.
•
When the printer is not in
use, raise the filament spool.
