Ver. 1.6 June
2015
da Vinci
Jr.1.0
P 6
First retrieve
fi
lament spool to install the
fi
lament
spool axle ring.
Place the assembled
fi
lament spool (with the spool axle
rings) on the
fi
lament holder on the left side of the printer.
Pull out a section of the
fi
lament and insert it into the
feed port.
Caution: Pay attention to the direction the
fi
lament is being pulled out and ensure that the
fi
lament spool axle is being rotated in the correct
manner.
Open the release arm and push the
fi
lament all the way
to the bottom so that the front end of the
fi
lament is
completely inserted into the feed module.
Take out and separate the
fi
lament spool
axle ring into its two components.
Install the sensor chip. Please pay special attention to
the position of the installation holes on the chip.
Insert the
fi
lament spool axle ring components
to either side of the
fi
lament spool, and use a
cruciform screwdriver to tighten and secure the
rings to the axle to complete the installation of
the
fi
lament spool axle rings.
1
2
3
4
5
6
7
Load Filament
CHANGE SPOOL
