Xylem WTW UV 701 IQ SAC, Instructions Manual

Page: 21 / 58

UV 70x IQ SAC
Commissioning
21 ba77046e02 05/2017
3.4.4 Settings for virtual sensors
Carrying out
settings
Using <S>, switch from the measured value display to the main menu of the
settings. Then navigate to the setting menu (setting table) of the sensor. The
procedure is described in detail in your IQ S
ENSOR
N
ET
system operating
manual.
Default values are marked in bold.
Quit
- The display switches to the next higher
level without storing the new settings.
Menu item Settings Explanations
Menu item Settings Explanations
Measuring mode

SAC 254, dissolved

SAC 254, total

UVT 254, total

CODds correl.

CODto correl.

TOC correl.

BOD correl.

DOC correl.

UVT 254, dissolved
The measured parameter is displayed
in the selected citation form.
Measuring range
- Display of the measuring range
(see chapter 8 T
ECHNICAL DATA
).
Cal - # raw value 1
Value pairs of the user calibration (see section 4.3.2).
Note: Leave those values unchanged during the initial commission
-
ing.
Cal - ref. value 1
Cal - # raw value 2
Cal - ref. value 2
Main sensor
Information that there are further sen
-
sor overlapping settings in the setting
menu of the relevant main sensor
(
Meas. interval
,
Cleaning duration Air
,
Signal smoothing
etc.).
Save and quit
- The system confirms the saving of the
settings and the display switches to the
next higher level.