Commissioning
NiCaVis 705 IQ TS
22
ba77189e01
05/2017
3.4.5 Settings of the secondary sensor (TSS measurement)
Carrying out
settings
Using <S>, switch from the measured value display to the main menu of the
settings. Then navigate to the setting menu (setting table) of the sensor. The
procedure is described in detail in your IQ S
ENSOR
N
ET
system operating
manual.
Default values are marked in bold.
Main sensor
Information that there are further sen
-
sor overlapping settings in the setting
menu of the relevant main sensor
(
Meas. interval
,
Cleaning duration Air
,
Signal smoothing
etc.).
Save and quit
-
The system confirms the saving of the
settings and the display switches to the
next higher level.
Quit
-
The display switches to the next higher
level without storing the new settings.
* The UVT-254 value is standardized to 10 mm gap width.
Menu item
Settings
Explanations
Menu item
Settings
Explanations
Measuring mode
TSS
Display of the measuring mode
(TSS = total suspended solids measure
-
ment)
Measuring range
-
Display of the measuring range
(see chapter 8 T
ECHNICAL
DATA
).
Cal - # raw value 1
Value pairs of the user calibration for TSS measurement (see section
4.3.2).
Note: Leave those values unchanged during the initial commission
-
ing.
Cal - ref. value 1
Cal - # raw value 2
Cal - ref. value 2
Main sensor
Information that there are further sensor
overlapping settings in the setting menu of
the relevant main sensor (
Meas. interval
,
Cleaning duration Air
,
Signal smoothing
etc.).
All manuals and user guides at all-guides.com
