Xylem LOWARA e-SV Series, Installation, Operation And Maintenance Manual

Page: 21 / 48

en - Original instructions
e-SV series - Installation, Operation and Maintenance Manual 21
8. Install a pressure gauge (or a vacuum pressure gauge, in case of suction lift installation) on
the suction side, and a pressure gauge on the discharge side, for checking the actual
operating pressure of the pump unit.
9. To exclude the unit from the system for the purpose of maintenance, install:

An on-off valve on the suction side

An on-off valve on the discharge side, downstream the check valve and pressure gauge,
also useful for regulating the flow rate.
10. On the suction side, install a device to prevent the absence of liquid (float or probes), or a
minimum pressure device.
11. Sufficiently submerge the end of the suction pipe in the liquid, in order to prevent any air
from penetrating through the suction vortex when the level is at the minimum
12. In case of suction lift installation, the suction pipe must have an increasing slope towards
the unit exceeding 2%; to avoid air pockets; also install:

A foot check valve that guarantees full opening (full section)

A filling on-off valve to facilitate the removal of the air and priming.
4.3.2 Flange forces and torques
Figure 13: Flange forces and torques
Model DN, mm Forces, N (lbf) Torques, Nm (lbf·in)
Fx Fy Fz Mx My Mz
1, 3SV 25 200 (45) 180 (41) 230 (52) 240 (2124) 160 (1416) 190 (1682)
5SV 32 260 (59) 240 (54) 300 (68) 310 (2744) 210 (1859) 250 (2213)
10SV 40 330 (74) 300 (68) 370 (83) 390 (3452) 270 (2390) 310 (2744)
15, 22SV 50 450 (101) 400 (90) 490 (110) 420 (3718) 300 (2656) 340 (3010)
33SV 65 1800 (405) 1700 (382) 2000 (450) 1500 (13
276)
1050
(9294) 1200 (10
621)
46SV 80 2250 (506) 2050 (461) 2500 (562) 1600 (14
161)
1150 (10
179) 1300 (11
506)
66, 92SV 100 3000 (675) 2700 (607) 3350 (753) 1750 (15
489)
1250 (11
064) 1450 (12
834)
125SV 125 3700 (832) 3300 (742) 4100 (922) 2100 (18
587)
1500 (13
276) 1750 (15
489)
ES
V_
M
00
14
_A_
sc
Mz
Mx
My
Fy
Fz
Fx
y
x z