Xylem Flygt FGC 400, Installation, Operation And Maintenance Manual

Page: 48 / 64

Part Description
Float High Level The water level is above the configured level for a
defined time.
Float Low Level The water level is below the configured level for a
defined time.
Undervoltage The voltage is below the configured level for a
defined time.
Overvoltage The voltage is above the configured level for a
defined time.
Volt Phase Failure The voltage difference between the phases is too
large.
Volt Phase Rotation The input power phases are connected in the
wrong order.
Station Inhibit The pumping station is blocked.
Personnel Alarm The on-site personnel failed to acknowledge their
presence within a defined time. The GP Input
Usage parameter must be configured to Personnel
Alarm.
Test Call The alarm is manually triggered and is used to
confirm the communication settings.
Station Overflow The alarm when the water level is above the
configured level for the overflow float switch for a
defined time.
Maximum Run Time After a defined duration, the pump stops for a
defined stop time.
This alarm starts when the duration is reached for a
defined number of consecutive pump cycles.
To turn on the alarm, the Mode parameter must be
set to the Alarm and Stop Pump value.
Default values:
• Duration: 30 min
• Stop Time: 120 s
• Pump Cycles: 3
Fail To Start The pump current is below a defined level at the
pump start.
Service Interval The alarm starts when a defined total pump runs
time elapses.
Pump 1 Overcurrent The pump current exceeds a defined percentage
over a defined full load current.
Pump 2 Overcurrent The pump current exceeds a defined percentage
over a defined full load current.
Pump 1 Current Phase Imbalance The current phase imbalance exceeds a defined
limit for a defined time.
Pump 2 Current Phase Imbalance The current phase imbalance exceeds a defined
limit for a defined time.
11 User Interface
46 Flygt FGC 400 Installation, Operation, and Maintenance