en – Original Instructions
e-IXP, e-IXPC, e-IXPF series – Additional Installation, Operation and Maintenance Instructions
19
4.4.1
Disassembling the protections
1.
Top fastener
2.
Top coupling protection
3.
Bottom fastener
4.
Side fasteners
5.
Bottom coupling protection
6.
Adjustment ring
1.
Unscrew the side fasteners.
2.
Unscrew the top fastener.
3.
Remove the top protection.
4.
Unscrew the bottom fastener.
5.
Remove the bottom protection.
6.
Open and lift the adjustment ring.
4.4.2
Checking the coupling alignment
Figure 1: Standard coupling
Figure 2: Coupling with spacer
1.
Ruler
2.
Thickness gauge
See Figure 1 or Figure 2, depending on the type of coupling.
1.
Place a ruler on the half-couplings.
2.
Measure the distances at the points shown in the figure.
3.
Turn the coupling by hand a little and repeat the measurement.
4.
Repeat step 3 several times: the radial alignment is correct if the distances in relation to the
corresponding axes are the same at all points.
5.
Check the distance between the half couplings with a feeler gauge.
6.
Turn the coupling by hand a little and check the distance again.
7.
Repeat step 6 several times: the axial alignment is correct if the distances are the same at all
points.
XIP_M0010_A_sc
5
2
6
1
4
3
XI
P_M0
01
3_A_sc
1
2
XI
P_M0
01
7_A_sc
1
2
