Xylem CentriPro PC PLUS, Installation, Operation And Maintenance Manual

Page: 6 / 12

6 7
ELECTRICAL CONNECTION AND STARTING
Failure to comply may cause unit and/or pump failure
WARNING
Never take the electronic board out of the control box.
The wiring diagram inside the terminal block indicates how
to make the correct connection. Incorrect connections will
destroy the electronic circuit.
The cable used for connection must be three-wire with a
compulsory ground.
The cable outer diameter should be 7.5mm minimum and
10.5mm maximum. One of the leading ends of the cable must
be lower than the position of the fixing screws while the cable is
being connected to the power as shown in Fig.1
The four screws fastening the panel board and the two cable
stands for fixing cable must be well fastened to avoid water
entering the control box and damagi ectronic circuit.
This part must be
lower than the fixing
nuts.
The four
screws must be
fastened.
The two nuts for fixing
the cable must be
tightened firmly.
Three-wire cable
with OD 7.5mm ~
10.5mm
Inlet
Fig. 1
111mmmmm
1
Pump
2
Barrel
Union
3 O Ring
5 O Ring
4
PC PLUS
Press
Control
ASSEMBLY INSTRUCTIONS
1 Secure the pump on a flat even surface.
2
Screw the barrel union provided into the discharge port of the pump.
3 Place the O Ring into the recess of the barrel union discharge.
4
Screw the P C
PL
U
S
Press Control into the discharge of the barrel
union by holding the PC PLUS steady and rotate the barrel union anti
clockwise until secured.
5
The
PC
PLUS is now secured to the pump and ready to operate.
Special Note
The
PC PLUS
is factory fitted with plug and play power leads which connect
directly to the matching leads as fitted to the pump. These leads are a press fit by
hand and do not require the services of an electrician.
The power lead to the wall socket is supplied with the pump.
6 7
ELECTRICAL CONNECTION AND STARTING
Failure to comply may cause unit and/or pump failure
WARNING
Never take the electronic board out of the control box.
The wiring diagram inside the terminal block indicates how
to make the correct connection. Incorrect connections will
destroy the electronic circuit.
The cable used for connection must be three-wire with a
compulsory ground.
The cable outer diameter should be 7.5mm minimum and
10.5mm maximum. One of the leading ends of the cable must
be lower than the position of the fixing screws while the cable is
being connected to the power as shown in Fig.1
The four screws fastening the panel board and the two cable
stands for fixing cable must be well fastened to avoid water
entering the control box and damagi ectronic circuit.
This part must be
lower than the fixing
nuts.
The tthhrreeee
screws must be
fastened.
The two nuts for fixing
the cable must be
tightened firmly.
Three-wire cable
with OD 7.5mm ~
10.5mm
Inlet
Fig. 1
111mmmmm
1
Pump
2
Barrel
Union
3 O Ring
5 O Ring
4
MP PLUS
Press
Control
ASSEMBLY INSTRUCTIONS
1 Secure the pump on a flat even surface.
2
Screw the barrel union provided into the discharge port of the pump.
3 Place the O Ring into the recess of the barrel union discharge.
4
Screw the MP PLUS Press Control into the discharge of the barrel
union by holding the MP PLUS steady and rotate the barrel union anti
clockwise until secured.
5
The MP PLUS is now secured to the pump and ready to operate.
Special Note
The MP PLUS is factory fitted with plug and play power leads which connect
directly to the matching leads as fitted to the pump. These leads are a press fit by
hand and do not require the services of an electrician.
The power lead to the wall socket is supplied with the pump.