4115T Light Duty Industrial PC Appendix C – Power-On Self-Test Messages
60 143926(A)
Error Messages
Cause/Solution
SYSTEM HALTED, (CTRL-ALT-
DEL) TO REBOOT ...
The present boot attempt has been aborted and the system must be
rebooted. Press and hold down the CTRL and ALT keys and press DEL.
WRONG BOARD IN SLOT
PLEASE RUN EISA
CONFIGURATION UTILITY
The board ID does not match the ID stored in the EISA non-volatile memory.
When this error appears, the system will boot in ISA mode, allowing you to
run the EISA Configuration Utility.
FLOPPY DISK(S) FAIL (80)
Unable to reset floppy subsystem
FLOPPY DISK(S) FAIL (40)
Floppy type dismatch
HARD DISK(S) FAIL (80)
HDD reset failed
HARD DISK(S) FAIL (40)
HDD controller diagnostics failed
HARD DISK(S) FAIL (20)
HDD initialization error
HARD DISK(S) FAIL (10)
Unable to recalibrate fixed disk
HARD DISK(S) FAIL (08)
Sector Verify failed
MANUFACTURING POST LOOP.
System will repeat POST procedure infinitely while the P15 of keyboard
controller is pulled low. This is also used for M/B burn in test.
BIOS ROM CHECKSUM ERROR -
SYSTEM HALTED.
The checksum of ROM address F0000H-FFFFFH is bad.
MEMORY TEST FAIL.
BIOS reports the memory test failed if the onboard memory is tested error.
