70
142214 (F)
APPENDIX E – TSKAM JUMPER AND SWITCH
SETTINGS
Xycom Automation produced two different TSKAM boards for the 3600 units. To
determine which TSKAM board is used with your unit check the jumper numbers
on the board.
If the TSKAM board has both JP12 and JP17 connectors present, it is TSKAM
Board 2, Part Number 142430-001/2. See Table E - 2for the jumper and switch
settings for this board.
If the TSKAM board has neither of these connectors, it is TSKAM Board 1, Part
Number 141438-001. See Table E - 1 for the jumper and switch settings for this
board.
TSKAM Board 1, Part Number 141438-001 2
Table E - 1 lists the jumper and switch settings for the TSKAM 1.
Table E - 1. Jumper and Switch Settings for TSKAM 1
Switches/Jumpers Position/Setting
Function
SW1 (1-4)
All OFF
Keypad type
SW2 (1-4)
All OFF
Reserved
JP3
A
B
Connects H8 keyboard controller pin P8-4/IRQ3*
to HOST_KBDATA
Connects H8 keyboard controller pin P8-4/IRQ3* to
programming header P6 pin 4
JP4
A
B
Connects H8 pin P8-5 to H8 MDATA
Connects H8 pin P8-5 to H8 programming header
P6 pin 3
JP5
A
B
Connects H8 pin P8-1 to H8 MCLK
Connects H8 pin P8-1 to program header P6 pin 9
JP7
A
B
Enables H8 ROM access
Disables H8 ROM access
JP8
In
Out
Connects H8 STBY* pin to program header P6 pin
11
Disconnects H8 STBY* pin from program header
JP9
In
Out
Remote switch interrupt connected to H8
Remote switch interrupt not connected to H8
JP14
A
B
3.3V LCD Power
5V LCD Power
indicates factory default position
