Xycom 3510T, Manual

Page: 77 / 107

Chapter Five – Keypad Utility for 3535
77
2. Press
F
1 and select
CUT
.
3. Press
ENTER
. Cut should still be highlighted, but the cursor will appear on the Edit
line. Move the cursor on the last character to cut and press
ENTER
.
The last character of every macro is the end of the macro (EOM) and cannot be
deleted.
Copy copies a sequence of scan codes from the macro into memory. To select the
section to copy:
1. Place the cursor on the first character to copy. Press
F
1 and select Copy.
2. Press
ENTER
. Copy should still be highlighted, but the cursor will appear on the
Edit line.
3. Move the cursor on the last character to copy and press
ENTER
.
The copied item does not appear on the screen until you select Paste.
Paste inserts a sequence of scan codes (which were saved in memory using Copy)
into the macro. To paste a sequence of scan codes that were previously copied,
position the cursor where you want the text to appear and then press
F
1. Select Paste
and then press
ENTER
. Codes displays a table of keys and their scan codes in Hex.
See the Codes section in this chapter for a complete code listing. Hex/Decimal toggles
between displaying the scan codes in Hex and Decimal formats. Insert toggles
between insert and overtype mode.
Upload Menu
Use the Upload Menu to choose which data to load. Choices in this menu are:
Combo Keypad, Keypad Version, and Exit.
Command Description
Combo Keypad Commands the keyboard controller to send its entire macro set for the keypad.
Keypad Version Commands the keyboard controller to send its firmware revision number.
Exit Returns to the Main Menu.
Note
Only one macro set may reside in memory at one time.
A checksum will be calculated during transmission. If an error occurs, an error
message will display.