XVision XSD10Z-2, Manual

Page: 20 / 24

20
7.8 GROUP SETUP
Group Number: [1~8]
Select Group number to edit. If a selected Group number is not defined, ‘UNDEFINED’ will be displayed under the selected
pattern number.
Clear Group:
[CANCEL/OK]
Deletes data in current Group
Edit Group : Allows the selected Group to be edited.
7.8.1 Edit Group
- Press the NEAR key in ‘NO’ list to start Group setup.
- Note that a maximum of 20 Functions are allowed in a Group. Move the cursor up/down and press NEAR key to set up.
z
Set up Action, Dwell time and Option.
Move the cursor Left/Right to select items and move cursor Up/Down to change each value.
- Action ### [NONE/PRESET/SWING/PATTERN]
- DWELL
[0 seconds~4 minutes]
Sets Dwell Time between functions
- OPT (Optional)
This should be set to the preset speed when in Preset Mode, OR the number of repetitions when in Pattern or Swing Mode
is selected.
z After finishing setting up the Action, press the NEAR key to move up one level in the menu. Move the cursor Up/ Down to
select another Action number and repeat the above steps to edit the next selected group Action.
z After setting up all the Actions, press the FAR key to exit. Then move the cursor to SAVE then press the NEAR key to save the
Group data.
GROUP SETUP
GROUP NO. 1
UNDEFINED
CLEAR GROUP CANCEL
<EDIT GROUP>
BACK
EXIT
EDIT GROUP 1
NO ACTION ### DWELL OPT
1 NONE
2 NONE
3 NONE
4 NONE
5 NONE
SAVE
CANCEL [NEAR: EDIT]
EDIT GROUP 1
NO ACTION ### DWELL OPT
1 NONE
2 NONE
3 NONE
4 NONE
5 NONE
SAVE [NEAR: EDIT ACT]
CANCEL [FAR: EDIT END]
EDIT GROUP 1
NO ACTION ### DWELL OPT
1 PRESET 1 00:03 360
2 NONE
3 NONE
4 NONE
5 NONE
SAVE [ :MOVE CURSOR]
CANCEL [ :CHANGE VALUE]